Stone Veneer Installation Guide !

Preparing the Surface
Before installing any Stone Selex products to a wall makes sure the surface is clean and free of any paint, dust or debris. Dirt and dust on the wall could lessen the bond between the stone and the masonry surface.

Installation on wood, plywood, paneling, wallboard
The surface must be prepared before the mortar can be applied. It is important to note that installation of stones on an outdoor wood surface requires the installation of a moisture barrier. Apply a felt paper to the entire surface of the project (to prevent any water damage to the wooden surface) use a hand stapler to firmly secure it to the wood surface. After the felt paper is attached to the wood you can continue with the installation as described below.

Expand metal lath onto the surface and use galvanized nails or staples every 4-6” to attach the lath to the surface. Keep in mind that it is difficult to attach stone to loose metal lath, so keep it tight across the surface and as flat as possible. After the metal lath is attached securely apply a thin layer of type S mortar (about ¼” scratch coat) to the lath. Wait till the scratch coat is completely dry before attaching the stones.

Installation on brick, concrete, or any other masonry substrate.
Stones can be attached directly to these surfaces without any preparations using type “S” mortar. It is very important to have the surface dust, dirt and paint free as described in the “Preparing the Surface” section.



window film
naples florida real estate